Új hozzászólás Aktív témák

• #10972 Panhard tag Intruder2k5 #10954

  Új Válasz 2011-03-29 23:06:26 #10972

  Új hozzászólás

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  Privát üzenet küldése

  

  Panhard

  tag

  válasz Intruder2k5 #10954 üzenetére

  Csatlakoztam rá soros kábellel, itt van amit bootoláskor írt:

  =~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2011.03.29 22:46:45 =~=~=~=~=~=~=~=~=~=~=~=
  
  
  U-Boot 1.1.4 (Apr 9 2009 - 12:29:57)
  
  AP93 (ar7240) U-boot
  DRAM:
  sri
  #### TAP VALUE 1 = 7, 2 = 8
  32 MB
  id read 0x100000ff
  flash size 4194304, sector count = 64
  Flash: 4 MB
  Using default environment
  
  In: serial
  Out: serial
  Err: serial
  Net: ag7240_enet_initialize...
  No valid address in Flash. Using fixed address
  : cfg1 0xf cfg2 0x7014
  eth0: 00:03:7f:09:0b:ad
  eth0 up
  No valid address in Flash. Using fixed address
  : cfg1 0xf cfg2 0x7214
  eth1: 00:03:7f:09:0b:ad
  ATHRS26: resetting s26
  ATHRS26: s26 reset done
  eth1 up
  eth0, eth1
  Autobooting in 1 seconds
  ## Booting image at 9f020000 ...
  Uncompressing Kernel Image ... OK
  
  Starting kernel ...
  
  Linux version 2.6.32.10 (openwrt@wrt1.marcant.net) (gcc version 4.3.3 (GCC) ) #20 Tue Apr 6 15:01:26 CEST 2010
  bootconsole [early0] enabled
  CPU revision is: 00019374 (MIPS 24Kc)
  Atheros AR7240 rev 2, CPU:400.000 MHz, AHB:200.000 MHz, DDR:400.000 MHz
  Determined physical RAM map:
  memory: 02000000 @ 00000000 (usable)
  Initrd not found or empty - disabling initrd
  Zone PFN ranges:
  Normal 0x00000000 -> 0x00002000
  Movable zone start PFN for each node
  early_node_map[1] active PFN ranges
  0: 0x00000000 -> 0x00002000
  Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
  Kernel command line: rootfstype=squashfs,yaffs,jffs2 noinitrd console=ttyS0,115200 board=TL-WR741ND
  PID hash table entries: 128 (order: -3, 512 bytes)
  Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
  Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
  Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
  Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
  Writing ErrCtl register=00000000
  Readback ErrCtl register=00000000
  Memory: 29332k/32768k available (2101k kernel code, 3436k reserved, 397k data, 152k init, 0k highmem)
  SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
  Hierarchical RCU implementation.
  NR_IRQS:56
  Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200)
  Mount-cache hash table entries: 512
  NET: Registered protocol family 16
  MIPS: machine is TP-LINK TL-WR741ND
  registering PCI controller with io_map_base unset
  bio: create slab <bio-0> at 0
  PCI: fixup device 0000:00:00.0
  pci 0000:00:00.0: PME# supported from D0 D1 D3hot
  pci 0000:00:00.0: PME# disabled
  PCI: mapping irq 48 to pin1@0000:00:00.0
  Switching to clocksource MIPS
  NET: Registered protocol family 2
  IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
  TCP established hash table entries: 1024 (order: 1, 8192 bytes)
  TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
  TCP: Hash tables configured (established 1024 bind 1024)
  TCP reno registered
  NET: Registered protocol family 1
  squashfs: version 4.0 (2009/01/31) Phillip Lougher
  Registering mini_fo version $Id$
  JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
  yaffs Mar 28 2010 17:53:41 Installing.
  msgmni has been set to 57
  io scheduler noop registered
  io scheduler deadline registered (default)
  Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
  serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
  console [ttyS0] enabled, bootconsole disabled
  console [ttyS0] enabled, bootconsole disabled
  Atheros AR71xx SPI Controller driver version 0.2.4
  m25p80 spi0.0: w25x32 (4096 Kbytes)
  Searching for RedBoot partition table in spi0.0 at offset 0x3fe000
  Searching for RedBoot partition table in spi0.0 at offset 0x3ff000
  No RedBoot partition table detected in spi0.0
  spi0.0: no WRT160NL signature found
  Creating 5 MTD partitions on "spi0.0":
  0x000000000000-0x000000020000 : "u-boot"
  0x000000020000-0x000000160000 : "kernel"
  0x000000160000-0x0000003f0000 : "rootfs"
  mtd: partition "rootfs" set to be root filesystem
  mtd: partition "rootfs_data" created automatically, ofs=29A000, len=156000
  0x00000029a000-0x0000003f0000 : "rootfs_data"
  0x0000003f0000-0x000000400000 : "art"
  0x000000020000-0x0000003f0000 : "firmware"
  ag71xx_mdio: probed
  eth0: Atheros AG71xx at 0xba000000, irq 5
  eth1: Atheros AG71xx at 0xb9000000, irq 4
  Atheros AR71xx hardware watchdog driver version 0.1.0
  TCP westwood registered
  NET: Registered protocol family 17
  Distributed Switch Architecture driver version 0.1
  eth0[0]: detected a Atheros AR7240 built-in switch
  dsa slave smi: probed
  802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
  All bugs added by David S. Miller <davem@redhat.com>
  VFS: Mounted root (squashfs filesystem) readonly on device 31:2.
  Freeing unused kernel memory: 152k freed
  Please be patient, while OpenWrt loads ...
  gpio-buttons driver version 0.1.2
  input: gpio-buttons as /devices/platform/gpio-buttons/input/input0
  Button Hotplug driver version 0.3.1
  eth0: link up (1000Mbps/Full duplex)
  - preinit -
  Registered led device: tl-wr741nd:green:system
  Registered led device: tl-wr741nd:green:qss
  Press the [f] key and hit [enter] to enter failsafe mode
  - regular preinit -
  switching to jffs2
  mini_fo: using base directory: /
  mini_fo: using storage directory: /overlay
  - init -
  eth0: link down
  
  Please press Enter to activate this console. eth0: link up (1000Mbps/Full duplex)
  device lan1 entered promiscuous mode
  device eth0 entered promiscuous mode
  device lan2 entered promiscuous mode
  device lan3 entered promiscuous mode
  device lan4 entered promiscuous mode
  PPP generic driver version 2.4.2
  ip_tables: (C) 2000-2006 Netfilter Core Team
  NET: Registered protocol family 24
  nf_conntrack version 0.5.0 (460 buckets, 1840 max)
  CONFIG_NF_CT_ACCT is deprecated and will be removed soon. Please use
  nf_conntrack.acct=1 kernel parameter, acct=1 nf_conntrack module option or
  sysctl net.netfilter.nf_conntrack_acct=1 to enable it.

  Nem tudom mi itt a hiba, de talán már van remény, holnap folytatom. Üdv!

Új hozzászólás Aktív témák