-
Fototrend
TP-Link WR1043ND - N450 router
Új hozzászólás Aktív témák
-
DiabloCorsa
őstag
Itt a Kernel az első USB -től végig.
4.789257] usbcore: registered new interface driver usbfs
[ 4.794936] usbcore: registered new interface driver hub
[ 4.800438] usbcore: registered new device driver usb
[ 4.811558] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
[ 4.819845] ehci-platform: EHCI generic platform driver
[ 4.825281] ehci-platform ehci-platform: EHCI Host Controller
[ 4.831133] ehci-platform ehci-platform: new USB bus registered, assigned bus number 1
[ 4.839260] ehci-platform ehci-platform: irq 3, io mem 0x1b000000
[ 4.856487] ehci-platform ehci-platform: USB 2.0 started, EHCI 1.00
[ 4.863926] hub 1-0:1.0: USB hub found
[ 4.868218] hub 1-0:1.0: 1 port detected
[ 4.873283] kmodloader: done loading kernel modules from /etc/modules-boot.d/*
[ 4.891078] init: - preinit -
[ 5.430775] usb 1-1: new high-speed USB device number 2 using ehci-platform
[ 5.543826] ar71xx: pll_reg 0xb8050014: 0x1a000000
[ 5.543863] eth0: link up (1000Mbps/Full duplex)
[ 5.577617] random: procd: uninitialized urandom read (4 bytes read, 21 bits of entropy available)
[ 8.791349] jffs2: notice: (322) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xref (0 dead, 0 orphan) found.
[ 8.816664] mount_root: loading kmods from internal overlay
[ 9.131081] kmodloader: loading kernel modules from /tmp/overlay/upper/etc/modules-boot.d/*
[ 9.561283] SCSI subsystem initialized
[ 9.611021] usb-storage 1-1:1.0: USB Mass Storage device detected
[ 9.618687] scsi host0: usb-storage 1-1:1.0
[ 9.623602] usbcore: registered new interface driver usb-storage
[ 9.630802] kmodloader: done loading kernel modules from /tmp/overlay/upper/etc/modules-boot.d/*
[ 9.973338] block: attempting to load /tmp/jffs_cfg/upper/etc/config/fstab
[ 9.983981] block: extroot: unsupported filesystem squashfs, try ext4, f2fs or ubifs
[ 9.992935] mount_root: switching to jffs2 overlay
[ 10.009935] urandom-seed: Seeding with /etc/urandom.seed
[ 10.025420] scsi 0:0:0:0: Direct-Access Samsung SSD 850 EVO 120G EMT0 PQ: 0 ANSI: 5
[ 10.037552] sd 0:0:0:0: [sda] 234441648 512-byte logical blocks: (120 GB/112 GiB)
[ 10.052556] sd 0:0:0:0: [sda] Write Protect is off
[ 10.057441] sd 0:0:0:0: [sda] Mode Sense: 17 00 00 08
[ 10.063519] sd 0:0:0:0: [sda] No Caching mode page found
[ 10.068993] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 10.098999] sda: sda1
[ 10.108743] sd 0:0:0:0: [sda] Attached SCSI disk
[ 10.117807] eth0: link down
[ 10.136001] procd: - early -
[ 10.139162] procd: - watchdog -
[ 10.857547] procd: - watchdog -
[ 10.861102] procd: - ubus -
[ 10.916733] random: ubusd: uninitialized urandom read (4 bytes read, 89 bits of entropy available)
[ 10.926324] random: ubusd: uninitialized urandom read (4 bytes read, 89 bits of entropy available)
[ 10.935481] random: ubusd: uninitialized urandom read (4 bytes read, 89 bits of entropy available)
[ 10.945542] random: ubusd: uninitialized urandom read (4 bytes read, 89 bits of entropy available)
[ 10.954680] random: ubusd: uninitialized urandom read (4 bytes read, 89 bits of entropy available)
[ 10.963952] random: ubusd: uninitialized urandom read (4 bytes read, 89 bits of entropy available)
[ 10.973287] random: ubusd: uninitialized urandom read (4 bytes read, 89 bits of entropy available)
[ 10.982809] procd: - init -
[ 11.428766] kmodloader: loading kernel modules from /etc/modules.d/*
[ 11.519384] ntfs: driver 2.1.32 [Flags: R/O MODULE].
[ 11.587388] ip6_tables: (C) 2000-2006 Netfilter Core Team
[ 11.642686] u32 classifier
[ 11.645502] input device check on
[ 11.649198] Actions configured
[ 11.681584] Mirror/redirect action on
[ 11.715034] nf_conntrack version 0.5.0 (445 buckets, 1780 max)
[ 11.745692] Loading modules backported from Linux version wt-2017-01-31-0-ge882dff19e7f
[ 11.753789] Backport generated by backports.git backports-20160324-13-g24da7d3c
[ 11.783829] ip_tables: (C) 2000-2006 Netfilter Core Team
[ 11.929706] xt_time: kernel timezone is -0000
[ 12.027191] PPP generic driver version 2.4.2
[ 12.034641] NET: Registered protocol family 24
[ 12.132268] ath: EEPROM regdomain: 0x0
[ 12.132295] ath: EEPROM indicates default country code should be used
[ 12.132309] ath: doing EEPROM country->regdmn map search
[ 12.132332] ath: country maps to regdmn code: 0x3a
[ 12.132347] ath: Country alpha2 being used: US
[ 12.132361] ath: Regpair used: 0x3a
[ 12.173867] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
[ 12.180378] ieee80211 phy0: Atheros AR9100 MAC/BB Rev:7 AR2133 RF Rev:a2 mem=0xb80c0000, irq=2
[ 12.422495] kmodloader: done loading kernel modules from /etc/modules.d/*
[ 14.127881] random: jshn: uninitialized urandom read (4 bytes read, 101 bits of entropy available)
[ 14.156250] random: ubusd: uninitialized urandom read (4 bytes read, 101 bits of entropy available)
[ 20.480626] random: nonblocking pool is initialized
[ 25.631388] fast-classifier: starting up
[ 25.635616] fast-classifier: registered
[ 27.788322] ar71xx: pll_reg 0xb8050014: 0x1a000000
[ 27.789728] eth0: link up (1000Mbps/Full duplex)
[ 27.815337] device eth0.1 entered promiscuous mode
[ 27.820250] device eth0 entered promiscuous mode
[ 27.841656] br-lan: port 1(eth0.1) entered forwarding state
[ 27.847403] br-lan: port 1(eth0.1) entered forwarding state
[ 29.848513] br-lan: port 1(eth0.1) entered forwarding state
[ 30.901376] ath: EEPROM regdomain: 0x815c
[ 30.901404] ath: EEPROM indicates we should expect a country code
[ 30.901421] ath: doing EEPROM country->regdmn map search
[ 30.901437] ath: country maps to regdmn code: 0x37
[ 30.901452] ath: Country alpha2 being used: HU
[ 30.901466] ath: Regpair used: 0x37
[ 30.901484] ath: regdomain 0x815c dynamically updated by user
[ 33.602518] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 33.693003] device wlan0 entered promiscuous mode
[ 42.111323] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 42.117986] br-lan: port 2(wlan0) entered forwarding state
[ 42.123596] br-lan: port 2(wlan0) entered forwarding state
[ 44.124480] br-lan: port 2(wlan0) entered forwarding stateOtt van:
Direct-Access Samsung SSD 850 EVO 120G EMT0 PQ: 0 ANSI: 5
234441648 512-byte logical blocks: (120 GB/112 GiB)[ Szerkesztve ]
Diablo. Ha gumira van szükséged ...
Új hozzászólás Aktív témák
- Kormányok / autós szimulátorok topicja
- Windows 11
- Építő/felújító topik
- Autóhifi
- Milyen notebookot vegyek?
- A fociról könnyedén, egy baráti társaságban
- eBay-es kütyük kis pénzért
- Computex 2024: Itt a Strix Pointra épülő Zenbook S 16
- Nem indul és mi a baja a gépemnek topik
- Honor Watch GS Pro - strapacska
- További aktív témák...
Állásajánlatok
Cég: Alpha Laptopszerviz Kft.
Város: Pécs
Cég: Ozeki Kft.
Város: Debrecen