Új hozzászólás Aktív témák

• #10811 zsolti.22 senior tag

  Új Válasz 2016-06-03 11:45:28 #10811

  Új hozzászólás

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  Privát üzenet küldése

  

  zsolti.22

  senior tag

  Új bugot fogtam nexuson :

  7.3(0)D1(1)

  vpc command added automatically on some FEX HIFs (vpc_num > 4096)
  CSCuz83616

  Symptom:
  "vpc xxxx" command is added on FEX interfaces automatically after the interfaces are brought up either as switchport access or as switchport trunk interfaces;
  The "xxxx" in the command is greater than 4096, and hence this command could not be deleted;
  "default int eth x/y/z" command for the affected interface does not help - the 'vpc xxxx' config stays on the interface;

  Conditions:
  The exact trigger is not known at the moment;
  The issue was seen for one single-homed N2K-C2248TP-E-1GE FEX attached to Nexus 7706 chassis with VPC feature enabled;
  At the same time the other FEX devices attached to the same N77 chassis did not have the issue;

  Workaround:
  The automatically added vpc command could be removed by the following steps:
  - configure on the affected FEX interface vpc command with vpc number lower than 4096,
  - remove the configured vpc command by negation of the command,

Új hozzászólás Aktív témák